Cisco Catalyst 3750-E - Page 36

Contents
xxxvi
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Configuring Unicast Reverse Path Forwarding 40-90
Configuring Protocol-Independent Features 40-90
Configuring Distributed Cisco Express Forwarding 40-90
Configuring the Number of Equal-Cost Routing Paths 40-92
Configuring Static Unicast Routes 40-93
Specifying Default Routes and Networks 40-94
Using Route Maps to Redistribute Routing Information 40-94
Configuring Policy-Based Routing 40-98
PBR Configuration Guidelines 40-99
Enabling PBR 40-100
Filtering Routing Information 40-101
Setting Passive Interfaces 40-102
Controlling Advertising and Processing in Routing Updates 40-102
Filtering Sources of Routing Information 40-103
Managing Authentication Keys 40-104
Monitoring and Maintaining the IP Network 40-105
CHAPTER 41 Configuring IPv6 Unicast Routing 41-1
Understanding IPv6 41-1
IPv6 Addresses 41-2
Supported IPv6 Unicast Routing Features 41-3
128-Bit Wide Unicast Addresses 41-3
DNS for IPv6 41-4
Path MTU Discovery for IPv6 Unicast 41-4
ICMPv6 41-4
Neighbor Discovery 41-4
Default Router Preference 41-4
IPv6 Stateless Autoconfiguration and Duplicate Address Detection 41-5
IPv6 Applications 41-5
Dual IPv4 and IPv6 Protocol Stacks 41-5
DHCP for IPv6 Address Assignment 41-6
Static Routes for IPv6 41-6
RIP for IPv6 41-7
OSPF for IPv6 41-7
EIGRP IPv6 41-7
HSRP for IPv6 41-7
SNMP and Syslog Over IPv6 41-7
HTTP(S) Over IPv6 41-8
Unsupported IPv6 Unicast Routing Features 41-8