Get ting St ar t e d
Star ting NAS Configuration
Cisco Small Business NSS 322, NSS 324, and NSS 326 Smart Storage Administration Guide 30
2
-
EX T3
—EXT3 is commonly used in the Linux environment. EXT3 provides
reliable file systems with a maximum capacity support up to
16 terabytes (TB).
• Encrypt disk volume:
-
No
—Do not encrypt the disk volume (default).
-
Yes
—Encrypt the disk volume using a password.
If you choose yes, the disk volume is encrypted with a password and provides an
extra layer of security against the theft of data in the event that disks are stolen.
File transfer performance to encrypted volumes is generally lower than non-
encrypted volumes.Th e default encry ption pas sw ord is the pas sw ord of the
administrator account.
STEP 23
Click
Next
.
The
Finish
window displays the ser ver configuration.
STEP 24
Click
Start Installation
. System begins initializing and the configuration progress
is displayed.
When the configuration is complete, you are returned to the
Co nfigu ri ng th e NAS
window in the Setup Wiza rd.
STEP 25
From the
Configuring the NAS
window, c lick
Next
to continue to M ap a Net w ork
Drive.
The
Map Network Drive
window opens. Continue to
Mapp ing a N etwork Driv e,
page 33
.
System Configuration Using the LCD Display
After connecting the equipment and pressing the Power butt on, the system boots,
loads the driver, and mounts the volume. You can optionally configure the NAS
device using the options in the LCD display.
NOTE
If you have configured the NAS using the Setup Wizard, you do not need to setup
the NAS using the LCD display.
NOTE
System configuration using the LCD display is supported on the NSS 324 and
NSS 326.
To Next Page
Loading...
Need help?
General
