Get ting St ar t e d
Reset Network Settings and Password
Cisco Small Business NSS 322, NSS 324, and NSS 326 Smart Storage Administration Guide 39
2
Set Up Network Shares
From the Network Shares menu, you can configure the following:
•
Sh are Fo l de r s
—Cr e a te sh are fol d e rs o n t h e NAS a nd ed i t t h e a ccess r i g hts
of the users and user groups to these share folders.
•
Quota
—Enable the quota settings for all the users and specify the quota
size they are allowed to use on each disk volume of the NAS.
For more inform ation, s ee
Network Shares, page118
.
Reset Network Settings and Password
You c an restore the network settings and p assword for your NAS device using the
r ese t b u tton l oc a ted o n t h e ba ck p a n e l . Th e NAS de vice sh o ul d be po w e r e d o n for
this proced ure. Using a pap er clip, pres s the reset but ton for 3 sec ond s , until the
NAS beeps.
The following settings are reset to default:
• System administration password:
admin
• Netw or k s et tings :
- Obtain TCP/IP settings automatically via DHCP
- Disable Jumbo Frame
- System management port - 8080
• System tools: IP filter settings - Allow all connections
• LCD panel password: (blank)
Inline Power Switch Module
An inline switch module is provide d for customers who wis h to have a convenient
means of turning the device off during extended inactivity. The switch module is
provided in compliance with the requirements of the
European Union Commission
Regulation No 1275/2008
. The device is also fully functional without the switch
module by plugging the power cord directly into the device. However, the switch
module must be used to comply with the European Union regulations.
To Next Page
Loading...
Need help?
General
