Figure 220: Installing the Standard Door
Step 2 Align the standard door hinges with the chassis hinges.
Step 3 Release the hinge pins.
Step 4 Pull the retention feature from the door (see Figure 221: Mounting the Mechanical Stop, on page 325).
Step 5 Loosen the screws and place the mechanical stop on the retention feature. (See Diagram 1 of Figure 221:
Mounting the Mechanical Stop, on page 325.)
Step 6 Place the retention feature on the pin present on the chassis. (See Diagram 2 of Figure 221: Mounting the
Mechanical Stop, on page 325.)
Step 7 Raise the door to slide the pin. (See Diagram 3 of Figure 221: Mounting the Mechanical Stop, on page 325.)
Step 8 Slide the mechanical stop to lock the door position and tighten the screws. (See Diagram 4 of Figure 221:
Mounting the Mechanical Stop, on page 325.)
Reinstall the door after installing all the other modules.
Note
Cisco ONS 15454 Hardware Installation Guide
324
Installing the ONS 15454 M6 Shelf
NTP-G258 Install the Standard Door of the ONS 15454 M6 Shelf
To Next Page
Loading...
