Figure 291: Replacing the Air Filter
Step 4 Replace the air filter with a new one if the air filter is dirty or clogged with dust.
Step 5 Attach the cable guide and insert the air filter into the shelf assembly.
The air filter must be inserted with the grid facing the shelf assembly as shown in Figure 291:
Replacing the Air Filter, on page 441.
Note
Step 6 Tighten the screw on the air-filter.
Stop. You have completed this procedure.
NTP-G262 Replace the Air Filter of the ONS 15454 M6 Shelf
Assembly
This procedure replaces the air filter of the ONS 15454 M6 shelf assembly.Purpose
New air filterTools/Equipment
• NTP-G252 Install the ONS 15454 M6 Shelf , on page 294
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the Electrostatic Discharge and Grounding
Guide for Cisco CPT and Cisco ONS Platforms .
Prerequisite Procedures
As NeededRequired/As Needed
RemoteOnsite/Remote
Provisioning or higherSecurity Level
Cisco ONS 15454 Hardware Installation Guide
441
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
NTP-G262 Replace the Air Filter of the ONS 15454 M6 Shelf Assembly
To Next Page
Loading...
