Figure 303: Extract the Fan-Tray Assembly
Step 4 Extract the fan tray partially using the handle in order to disconnect the backplane connector and wait until
the fan stops (see the following figure)
Figure 304: Fan-Tray Assembly Extracted Partially with Power Connector Disconnected
Step 5 When the fans have stopped, pull the fan-tray assembly completely out of the shelf assembly (see the following
figure).
Cisco ONS 15454 Hardware Installation Guide
459
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
NTP-G260 Replace the Fan-Tray Assembly of the ONS 15454 M6 Shelf Assembly
To Next Page
Loading...
