Modules
Setting Up SATA RAID or AHCI Mode 7 - 9
7
4. Press a key at system startup to begin installing Windows from your Microsoft
Windows 7 disc (make sure the DVD device is set at the top of the Boot
Sequence in the BIOS - see “Boot Option Priorities (Boot Menu)” on page 5 -
17).
5. Click Install Now.
6. Make sure your USB Flash drive or external USB hard disk is attached to one of
the USB ports on the computer.
7. Click “I accept the license terms” tickbox and click Next.
8. Click Custom (advanced).
9. Click to select Load Driver when the “Where do you want to install Windows?”
screen appears.
10. Click Browse and browse to the location you copied the files to on your USB Flash
drive or external USB hard disk (X: denotes your USB Flash drive or external USB
hard disk). The actual files to be copied will be dependant on your BIOS
Revision (to find your BIOS revision/version see “BIOS Revision/ KBC/EC
firmware Revision / VGA Card etc. (Main Menu)” on page 5 - 7).
For BIOS Revisions earlier than Ver 1.02.xx browse to the following:
• Windows 7 32bit - X:\00IRST\f6flpy\RSTe_f6_iaStorA_32\
• Windows 7 64bit - X:\00IRST\f6flpy\RSTe_f6_iaStorA_64\
For BIOS Revisions Ver 1.02.xx or later browse to the following:
• Windows 7 32bit - X:\AHCI\f6flpy\f6flpy-x32\
• Windows 7 64bit - X:\AHCI\f6flpy\f6flpy-x64\
11. Click OK > Next (or format the drive to your preferences).
To Next Page
Loading...
Need help?
General
