List of ACU events
C-10 Appendix C: System messages 99-145912-A
0810B-0 ADM ERROR Antenna software
version
Some error occurred during upload of software to
the antenna, which means that the antenna
software version is not as expected. Either the
software in the ACU, does not meet the minimum
version required by the antenna, the software
image in the ACU is corrupted or the upload
procedure failed because of a communication
error.
0810C-0 ADM ERROR File system integrity One or more file system partitions are corrupt. You
may have lost your settings and collected
statistics. If restarting the system does not help,
contact your service partner.
0810D-0 ADM ERROR Antenna software
upload
Some error occurred during upload of software to
the ACU, which means that the ACU software
version is not as expected. Either the software in
the ACU, does not meet the minimum version
required by the ACU, the software image in the
ACU is corrupted or the upload procedure failed
because of a communication error.
0810E-0 ADM ERROR RF calibration The RF calibration is not valid.
08800-0 ADM ERROR Internal power supply An internal power supply voltage is outside its
legal range.
08840-0 ADM WARNING Master PLL lock The master PLL has lost lock. Check the input
reference signal.
08841-0 ADM ERROR Tuner lock The internal tuner PLL was unable to lock.
08842-0 ADM WARNING GSC demodulator The GSC demodulator has reported an error.
08843-0 ADM WARNING DVBS demodulator The DVBS demodulator cannot be initialised and
loaded correctly.
08844-0 ADM WARNING BUC voltage The BUC voltage is out of range.
08845-0 ADM WARNING LNB voltage The LNB voltage is out of range.
08880-0 ADM ERROR WLAN configuration
error
Configuration of WLAN module failed.
08A00-0 ADM WARNING GX Core Module fan There is a problem with the Core Module fan.
Check/clean and replace if necessary.
Error
code
(ID)
ACU
PCB
Severity Description Explanation
Table C-2: ACU event messages (Continued)
To Next Page
Loading...
Need help?
General
