99-145912-A D-1
Appendix D
Command line interface D
D.1 Introduction
After you have done the initial configuration and connected the SAILOR VSAT system to
your network, you can use Telnet to configure the SAILOR VSAT system. You can also setup
VSAT modem parameters.
After successful login you can read and change settings. Use the command config
activate to activate the new settings in the ACU. You will need to refresh the browser
window before the changed settings become visible.
D.1.1 Telnet connection
You can access the command line interface via Telnet.
User name and password
Access to the SAILOR VSAT system system is protected by a user name and password. This
is the same user name and password that is used in the web interface under
ADMINISTRATION.
Telnet
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet session
do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, default login admin and default
password 1234.
Figure D-1: How to use the command line interface (example for telnet)
Every change is performed on the active satellite profile or the active VSAT
modem profile. Parameter identifiers are case sensitive.
H:\>telnet 192.168.0.1
acu login: admin
Password:
Connect to SAILOR
VSAT using IP address
UCLI:/$ config current_list
Read or change settings
Write new settings to
SAILOR VSAT
1
2
3
UCLI:/$ config activate
Figure D-2: Command line interface, login
To Next Page
Loading...
Need help?
General
