Configuration with the web interface
99-145912-A Chapter 6: Configuration 6-31
6.3.6 To send a diagnostics report
You can send automatically generated diagnostic reports at fixed
intervals. The diagnostic report contains information from the ADU and
ACU that are relevant for the service personnel during troubleshooting.
To set up sending a statistics report, do as follows:
1. Go to SETTINGS > Reports.
2. In the section DIAGNOSTICS REPORT enter the following:
•E-mail sender.
• E-mail recipients (comma separated).
• Send interval: Select disabled, day (default) with 2-minute
samples, week with hourly samples or month with hourly samples.
The report contains statistics data for the selected intervals.
3. Click Apply.
You can generate and send the diagnostic report at any time by clicking
Send now or at monthly intervals, then click Send monthly, or go to
the page HELPDESK and click Download to download it directly to
your computer. See also To download diagnostic and statistics reports
on page 8-2.
Figure 6-22: Statistics report (example)
To Next Page
Loading...
Need help?
General
