Site preparation
99-145912-A Chapter 3: Installation 3-9
3. Allow sufficient space so the nut is free of the welded seam and
there is room for tools (min. 50 mm).
4. Use the dimensions in the following figure to prepare the mast
flange for mounting of the ADU.
CAUTION! Avoid sharp edges where the flange is in
direct contact with the radome. Round all edges as much as
possible to avoid damaging the surface of the radome.
Figure 3-8: ADU mast flange, distance to the welded seam
Figure 3-9: ADU, bottom view
To Next Page
Loading...
Need help?
General
