Instrument Connections
The top panel of the instrument is equipped with the following
connection interfaces.
1. Ethernet port. Connects to a standard 8P8C ('RJ45') male plug
terminator
2. Charger power socket (12 Volt 3 Amp input). This may be used to
power the instrument and/or to charge the instrument's battery pack
3. USB socket. Provides a data connection between the instrument
and the vbXManager software's host computer
4. BNC sensor input (Channel 1)
5. BNC sensor input (Channel 2) OR LEMO seven-pin input*
(Channels 2 to 4)
6. LEMO four-pin tachometer input
* This feature is only available on the vbBalancer+ instrument model
Note: The comms and charger area's protective rubber gasket
should be kept closed and in place when collecting data in the field.
Doing so will help maintain the environmental sealing of the
instrument case.
To Next Page
Loading...