• Press Balance Planes then use the arrow keys to
highlight the number of balance planes to use.
• Press to select. This will display the Balance Weight
Setup Menu.
• From the Balance Weight Setup Menu press Plane A
Weight Position then use the arrow keys to highlight your
choice and press to select.
• If you select circumference arc or # fixed positions this will
open the Circumference or # Fixed Position sub-menus
where you need to specify the rotor circumference or the
number of fixed positions. Enter the required value then
press
Note: The circumference units used (inches or mm) are set in the
Balance Setup screen by pressing Weight Lin Dist then
Linear Distance.
• If you have selected dual plane balancing press Plane
B Weight Position and repeat the previous steps for Plane
B.
• Press repeatedly if necessary to return to the Balance
Setup Menu from where you will specify your sensor
settings. If you selected dual plane balancing, pressing
will automatically take you to the Balance Sensor Setup
Menu.
# Sensors
This option lets you specify the number and type of sensors you are
using. This menu also contains an option that allows the instrument
to recommend where to place trial weights (optional).
• If the Balance Sensor Setup Menu is not already displayed
press
# Sensors from the Balance Setup Menu then
select the number of sensors required and press
To Next Page
Loading...
Need help?
General
