Section 5: Balancing
Walk-through
This walk-through guides you through the process of balancing a
rotor using single and dual plane balancing. Dual plane balancing
requires additional steps; these extra steps are indicated with this
symbol
You will learn to:
• Take initial imbalance measurements
• Set up and apply trial weights
• Balance the rotor using correction weights
• Perform trim balancing to further reduce the vibration
• Save and review your balancing job
• Produce balancing reports
Step 1. Set Up a New Balance Job
• From the Main Menu press Balance then press
New Job to clear any previous settings.
• Press Setup. Use the options in the Balance Setup
Menu to choose the required settings for your balancing job.
The following screen shows the settings that were selected
for this walk-through.
To Next Page
Loading...
Need help?
General
