Note: The following functions are only available when viewing
multi-channel (two or more) and multi-domain (spectrum+waveform)
measurements.
Selecting a chart layout
• With the charts displayed press to display hint labels.
• Press Change View to alter the currently displayed
chart type. Press repeatedly to toggle between waveform or
spectrum displays for up to four channels, and
spectrum+waveform to view both measurement types
onscreen simultaneously for individual channels.
Changing how multi-chart layouts are displayed
• With the charts displayed press to display hint labels.
• Press then press Chart Data Change to open the
Multi Chart Layout screen.
• Press to choose which channels will be displayed in
your Multi Chart Layout.
• Press or to pick a layout from those listed. For
single channel displays you may choose waveform,
spectrum or spectrum+waveform. For multi-domain
measurements using three or more channels and with all
channels set to display simultaneously ('Show All Channels'
in the previous step), you may only select waveform or
spectrum for simultaneous display, not both.
Setting the Y Axis (Amplitude) Scale
Toggling the left axis scale between Linear, Log and dB will increase
or decrease the amplitude of displayed peaks allowing you to see
either the bigger picture or a more detailed view of the data. The
Linear scale is suitable for most cases. Log scaling (base 10) is more
useful for displaying vibration with both very large and very small
amplitudes.