Commtest Instruments vbBalancer - Page 6

vi
Section 8: Measurement Types and Their Uses.......82
Spectrum ............................................................................. 82
Waveform ............................................................................ 83
Tachometer Display ............................................................. 83
Bump Test ........................................................................... 84
Coast-down/Run up ............................................................. 85
Taking Multi-channel Simultaneous Measurements ............. 86
Setting up Sensors and Channels.............................................86
Saving Multi-channel Measurements ........................................87
Section 9: Taking Recordings ...................................89
Walk-through: Taking Recordings ........................................ 89
Taking Individual and Multiple Recordings ........................... 90
Saving Recordings............................................................... 91
Reviewing Recordings ......................................................... 91
Deleting Recordings............................................................. 93
Attaching Notes ................................................................... 93
Section 10: Creating, Editing and Deleting Items ....94
Storage Capacity and Recording Volume ............................ 94
How are Recordings Organized and Stored?....................... 94
Working with Folders ........................................................... 96
Creating a Folder.......................................................................96
Renaming a Folder .................................................................... 96
Deleting a Folder .......................................................................96
Restoring a Deleted or Over-Written Folder..............................96
Working with Machines ........................................................ 97
Creating Machine Structures.....................................................97
Creating Parameter Sets ...........................................................98
Adding Structures to Existing Machines....................................99
Copying Machine Structures ...................................................100
Renaming Machine Structures ................................................100
Deleting Machine Structures ...................................................101
Working with Sensors ........................................................ 101
Defining and Editing Sensors ..................................................101
Using the Bias Voltage Check.................................................103