Comnet CNGE3FE8MSPOE - Page 169

INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 169
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Object Description
Configuration
Guideline for
All Features
When the switch is running on Remote Mirroring mode, the administrator also needs to check
whether or not other features are enabled or disabled.
For example, the administrator is not disabled the MSTP on reflector port. All monitor traffic will be
blocked on reflector port.
All recommended settings are described as follows.
Impact source
port
reflector
port
intermediate
port
destination
port
Remote
Mirroring VLAN
arp_inspection High * disabled * disabled
acl Critical * disabled * disabled * disabled
dhcp_relay High * disabled * disabled
dhcp_snooping High * disabled * disabled
ip_source_guard Critical * disabled * disabled * disabled
ipmc/igmpsnp Critical un-conflict
ipmc/mldsnp Critical un-conflict
lacp Low o disabled
lldp Low o disabled
mac learning Critical * disabled * disabled * disabled
mstp Critical * disabled o disabled
mvr Critical un-conflict
nas Critical * authorized * authorized * authorized
psec Critical * disabled * disabled * disabled
qos Critical * unlimited * unlimited * unlimited
upnp Low o disabled
mac-based vlan Critical * disabled * disabled
protocol-based vlan Critical * disabled * disabled
vlan_translation Critical * disabled * disabled * disabled
voice_vlan Critical * disabled * disabled
mrp Low o disabled
mvrp Low o disabled
Note:
* -- required
o -- optional
Impact: Critical/High/Low
Critical 5 packets -> 0 packet
High 5 packets -> 4 packets
Low 5 packets -> 6 packets
Apply Click to apply changes.
Reset Click to undo any changes made locally and revert to previously saved values.