Comnet CNGE3FE8MSPOE - LLDP PoE Neighbor Over Ethernet Information

INS_CNGE3FE8MS[POE][HO] Rev. 11.7.17 PAGE 226
INSTRUCTION MANUAL CNGE3FE8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
PoE
This page provides a status overview for all LLDP PoE neighbors. The displayed table contains
a row for each interface on which an LLDP PoE neighbor is detected. The columns hold the
following information:
Object Description
Local Interface The interface for this switch on which the LLDP frame was received.
Power Type The Power Type represents whether the device is a Power Sourcing Entity (PSE) or Power Device
(PD).
If the Power Type is unknown it is represented as “Reserved”.
Power Source The Power Source represents the power source being utilized by a PSE or PD device.
If the device is a PSE device it can either run on its Primary Power Source or its Backup Power
Source. If it is unknown whether the PSE device is using its Primary Power Source or its Backup
Power Source it is indicated as “Unknown”
If the device is a PD device it can either run on its local power supply or it can use the PSE as
power source. It can also use both its local power supply and the PSE.
If it is unknown what power supply the PD device is using it is indicated as “Unknown”
Power Priority Power Power Priority represents the priority of the PD device, or the power priority associated
with the PSE type device’s interface that is sourcing the power. There are three levels of power
priority. The three levels are: Critical, High and Low.
If the power priority is unknown it is indicated as “Unknown”
Maximum Power The Maximum Power Value contains a numerical value that indicates the maximum power
in watts required by a PD device from a PSE device, or the minimum power a PSE device is
capable of sourcing over a maximum length cable based on its current configuration.
The maximum allowed value is 102.3 W. If the device indicates value higher than 102.3 W, it is
represented as “reserved”
Auto_refresh Check to refresh the page automatically every 3 seconds.
Refresh Click to refresh the displayed table starting from the input fields.