Working with Removable Drives 6-9
Writer: Karen Williams Saved by: Cheryl Love Saved date: 09/03/97 9:43 AM
Part Number: 220709-003 File name: Ch06.doc
Removing a Hard Drive from the MultiBay
Before removing a hard drive, Compaq recommends that you back
up all information on the hard drive.
To remove a hard drive from the MultiBay:
1. Save your work, exit all applications, and shut down
the computer.
2. Tilt the computer to access the MultiBay release mechanisms.
3. If the hard drive assembly has been secured in the MultiBay
with a single-bay security screw or a dual-bay security screw,
remove the screw with the Torx T-10 screwdriver included
with the computer.
4. Slide the MultiBay release latch back while pulling on the
hard drive assembly from the recess beneath the MultiBay.
This releases the hard drive assembly from the MultiBay.
5. Slide the hard drive assembly out of the MultiBay.
6. If you are not inserting another drive or a battery pack into the
MultiBay, insert the weight saver included with the computer.
For more information, refer to “Using the Weight Saver” in
this chapter.
To Next Page
Loading...
