ConMed Advantage - Page 103

95
MICROCHOICE
HANDPIECES
C
Group 3 Handpieces
PRECAUTION: Operating the shaver
blade or bur without fluid flow (dry)
may cause damage to the device or
cause the plastic hub to seize (melt).
NOTES:
1. Group 3 handpieces consist of
MicroChoice (MC9820, MC9828,
MC9840), Advantage (D9820, D9824,
D9920, D9924), and APEX (C9820,
C9824, C9828, C9840) Shaver
Handpieces.
2. When using the MicroChoice (MC9820)
and Advantage (D9820, D9920) Basic
Shaver Handpieces, and MicroChoice
Small Shaver Handpiece (MC9840) on
the Advantage controller, they can
ONLY be operated from Port 2 (Top
portion) using a footswitch. For
footswitch operation, see “2.1.7
Footswitch Operation (Advantage Top
Portion Only, PowerPro and E9000)” on
page 55.
3. When using the APEX Basic Large
Shaver Handpiece (C9820) and APEX
Small Shaver Handpiece (C9840) on the
Advantage controller, they can be
operated from either Port 1 or 2.
However, to use them in Port 2 the E9320
APEX Adapter must be used and can
only be controlled using a footswitch. For
footswitch operation information, see
“2.1.7 Footswitch Operation (Advantage
Top Portion Only, PowerPro and
E9000)” on page 55.
4. The following handpieces cannot be used
in Port 3 of the Advantage Controller
because they require a footswitch to
operate and there is no footswitch
associated with Port 3 (C9820, MC9820,
C9840, MC9840, D9820, and D9920).
5. The APEX Full-Function (C9828), and
2-Button (C9824) Shaver Handpieces can
be operated from all ports of the
Advantage Controller using the
handpiece buttons. However, to operate
these hand-pieces from Ports 2 and 3 the
E9320 APEX Adapter must be used.
They can also be operated from Ports 1
or 2 using a footswitch. For footswitch
operation, see “2.1.7 Footswitch
Operation (Advantage Top Portion Only,
PowerPro and E9000)” on page 55.
6. The MicroChoice Full-Function
(MC9828) and Advantage 2-Button
(D9824, D9924) Shaver Handpieces can
be operated from Ports 2 or 3 of the
Advantage Controller using the
handpiece buttons. They can also be
operated from Port 2 using a footswitch.
For footswitch operation, see “2.1.7
Footswitch Operation (Advantage Top
Portion Only, PowerPro and E9000)” on
page 55.