39
CONTROLLER
OPERATION
A
2.1.3.2 Switch 1 - “Day-to-Day”
Memory Storage Operation
NOTE: This switch applies to the E9000
and Power
Pro controller and to all ports of
the Advantage controller.
The Advantage, E9000 and Power
Pro
controllers have the capability of “Day-to-Day”
memory storage. “Day-to-Day” memory storage
retains handpiece settings between controller
uses (even if the controller power is turned off)
and is only available when “CONTROLLER
OPTIONS/FUNCTION” switch number 1 is set
to the “ON” position.
Selection of “Day-to-Day” memory bypasses
the controller start-up (default) settings.
“Day-to-Day” memory can be achieved at any
time by following steps 1 through 3 below.
1. Ensure controller power is off.
2. Place switch 1 on the E9000 and Power
Pro
controller, or the top and/or bottom of the
Advantage controller to the “ON” position,
depending upon which part of the
Advantage controller will be used
(Advantage controller shown).
3. Turn the controller on and utilize the
system.
The last handpiece setting (including irrigation
flow rate, top portion only on the Advantage
controller) will be the initial setting when the
controller is turned on again. If no change(s)
was made, the initial or default setting for that
handpiece(s) will be retained.
NOTE: If switch 1 is moved to “OFF” while
the controller is on, the initial handpiece
settings revert to the default settings when
the controller power is turned off and then on
again. See page 112 for handpiece default
settings.
4. To turn “Day-to-Day” memory off, place
switch 1 on the E9000 and Power
Pro
controller, or the top and/or bottom of the
Advantage controller to the “OFF” position,
depending upon which part of the controller
will be used.
To Next Page
Loading...
