Culligan
®
Softener and Filter
Program Log
Use this log to record the program settings for any Smart Controller (GBE) controlled softener or filter. Circle or enter the
observed value. Make additional copies to keep on file near the installation and with your local Culligan dealer.
Program Date: ___________ Installer: _____________________________ Site Location: ____________________
Smart Controller ESN: _____ Firmware Version: _____________________ oSoftener oFilter
Regeneration Initiation (check all that apply):
oTime Clock oMeter oAqua-Sensor oOther
Accessories
Aqua-Sensor Installed/Not Installed S Only
Debug ON/OFF S Only
Beeper Mode Always On
Always Off
12 Hr. Warnings
24 Hr. Warnings
Aux Input Normal/Alarm
Aux2 Output Type Normally On
Normally Off
Repeat Cycle
Aux2 Valv Pos
Aux2 Out Delay
Aux2 Out Active
Aux2 Out Off Repeat
Cycle
Aux3 Output Type Normally On
Normally Off
Repeat Cycle
Aux3 Valv Pos
Aux3 Out Delay
Aux3 Out Active
Aux3 Out Off Repeat
Cycle
SBT Sensor Installed/Not Installed S Only
Tank Diameter S Only
Salt Geometry Pellet/Rock/
Brick/Special
S Only
Remote Display Installed/Not Installed
Channel #
Radio Frequency 915
Modem Installed/Not Installed
Modem Location Main Control/
In Remote
Call Frequency
Time Zone GMT
Dealer ID
Date Phone #
Chlorinator Installed/Not Installed
Power Level
On Time
Meter Installed/Not Installed
Puls/Gal
Low Flow Limit
High Flow Limit
Service Phone #
Ext Filter Installed/Not Installed S Only
Filter Capacity S Only
Reset Capacity Yes/No S Only
First Time Setup
Month
Day
Year
Clock Type 12 Hr/24 Hr
Hour
Minutes
Unit Type Softener/Filter/R+C
Valve Type HE 1, HE 1.5,
HE 1 Twin,
4-Cycle, 5-Cycle,
Plat Plus
Units US Inch/Metric
Install Type Residential,
Commercial
S Only
Brining Type Downflow, Upflow,
Proportional
S Only
Tank Diameter S Only
Hardness S Only
Media Life F Only
Total Capacity F Only
Advanced Setup
Valve Type HE 1, HE 1.5,
HE 1 Twin,
4-Cycle, 5-Cycle,
Plat Plus
Units US Inch/Metric
Multitank System Single
Twin
Progress Flow
Alternating
Unbal Prog Flow
Prog Flow Trip
Progress Flow Master/Slave (_____)
Small Tank Trip
Prerinse Mode OFF/ON
Rinse If No Flow
Rinse For
Regeneration Setup
Total Capacity
Reserve Capacity S Only
Brining Type S Only
Time of Regen
Regen Mode Delayed/Immediate
Power Up Regen
Regen Lockout S Only
Media Life F Only
Cycle Times
Backwash
Brine Draw-Rinse
Fast Rinse Time
Fill Time
Regeneration Triggers
Flow Meter Can/Cannot
Aqua-Sensor Can/Cannot S Only
Regen Interval
Predict Mode OFF/ON S Only
Regen On
On Remote Display
Remote Display Installed/Not Installed
Channel #
Radio Frequency 915
Cat. No. 01022883
Rev. B 01/10/10
DCO # 000000
©2010 Culligan International Co. 9399 W. Higgins Rd., Rosemont Illinois 60018 USA www.culligan.com
Warning! If incorrectly installed, operated or maintained, this product
can cause severe injury. Those who install, operate, or maintain this
product should be trained in its proper use and warned of its dangers
before attempting to install, operate or maintain this product.