60 Culligan® Smart Controller (GBE) for Softeners and Filters
60 Cat. No. 01021161
Check Signal Strength
Check the signal strength once the control valve and wireless remote are setup. On the Softener Controller, go to the
Main Menu/Advanced setup/Diagnostics/Test Wireless to check signal strength. The signal strength indicator (SSI) will
show a value of between 0 and 8. If the SSI is at least 4, then the installation is complete. It the SSI drops below 4, then
it may be necessary to select an alternate location for the wireless remote.
1. From the HOME screen, press to view the main menu.
2. The screen displays the main menu. Press to select
6)DIAGNOSTICS.
3. The screen displays the main menu. Press to select
3)TEST WIRELESS. The screen displays the wireless test screen.
4. Press to test the signal strength. The screen displays the test number and total
number of attempts and the received signal strength indicator (RSSI). The system
will test the signal strength again and repeat until you press
again.
5. Press to save the settings and return to the home screen.
To Next Page
Loading...
Need help?
General
