Manual Regeneration 71
Cat. No. 01021161
Manual Regeneration
Follow either procedure to bypass the softener or to initiate a manual regeneration at the control valve or the remote display.
NOTE In multi-tank systems, the regeneration request is sent to the master control. It will allow the unit to
regenerate at the next available time.
NOTE Once regeneration is initiated the status can be changed only after the process is complete or by re-
setting the motor control in the Diagnostics menu.
Quick Manual Regeneration
1. From the HOME screen, press and hold to view the home screen plus a regen-
eration status line.
2. Press and hold for three (3) seconds. Regeneration will be delayed until a
specified later time. The screen displays REGEN TONITE on the home screen for
about one second.
3. To cancel a delayed regeneration, press and hold the for three (3) seconds.
The screen displays REGEN OFF on the home screen.
4. Continue to hold down for six (6) seconds. The screen displays REGEN NOW
and the softener will initiate an immediate regeneration.
5. If REGEN NOW or REGEN TONITE is selected, the home screen displays
Regenerating.
Standard Manual Regeneration
1. From the home screen, press to display the main menu.
2. From the main menu screen, press to view 2) MANUAL MODE.
3. Press . The screen displays the Manual Mode settings.
Standard Regeneration Manual Mode Settings
Setting Screen Display Range Changing the Setting
Manual
Mode
Regen Off
Regen
Now
Regen
Tonite
REGEN NOW is the default. Press
to select this option to begin
regeneration immediately.
REGEN OFF will cancel a pending regeneration by canceling the re-
generation trigger.
REGEN TONITE specifies that the softener will regenerate that night
at 2:00 a.m. (or at the preset regeneration time). The screen displays
two status messages: Softening >> and Regen Tonite >>.
4. Press to return to the home screen.
To Next Page
Loading...
Need help?
General
