CHAPTER 6 – BLUETOOTH® SET-UP & OPERATION
1 INTRODUCTION
The Omni2 allows a powerchair user to control multiple Bluetooth®-enabled devices. Typical applications include PC mouse
control or operation of a Smart device.
Up to four devices can be controlled. Two of which can be Apple iOS devices and two of which can be Windows or Android
devices.
1.1 OPERATIONAL RULES
Bluetooth® Mode will only be available if one or more devices are set to On in the Settings Menu. Refer to the Bluetooth®
Mode Screen Configuration section for further details.
The Omni2 and target Bluetooth® devices will remain paired until they are disconnected by the target device.
Once an Omni2 has been paired with a Bluetooth® device, the module remembers the device’s unique identifier. This means
the powerchair can be driven outside the operating range of the Bluetooth® connection and upon returning within range the
connection will be automatically reinstated.
1.2 SYSTEM CONFIGURATION
There are three configuration processes that need to be carried out – Bluetooth® Mode configuration, the Bluetooth® Mode
Screen Configuration and pairing with Bluetooth® Devices. Each is described in the following sections.
1.3 BLUETOOTH® MODE CONFIGURATION
An R-net Output Mode must be set to Bluetooth®. For the purposes of this section, the Mode Name will be assumed to be My
Devices. See programing example below.
Refer to the R-net Technical Manual SK77981 – Programming for further details.
To Next Page
Loading...
Need help?
General