Curtiss-Wright R-NET OMNI2 - 5.3 Switch Control Set-Up

Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 6 – Bluetooth Set-Up & Operation | 113
SK81935-01
5.3 SWITCH CONTROL SET-UP
Certain Omni2 commands can be assigned to iDevice commands. The Omni2 commands are detailed below.
Time-related deflections (nudges) of the SID in each of the four directions:
 Forward Short
 Reverse Short
 Left Short
 Right Short
 Forward Medium
 Reverse Medium
 Left Medium
 Right Medium
 Forward Long
 Reverse Long
 Left Long
 Right Long
The timings associated with the nudges are programmable. Refer to the Bluetooth® Programming chapter for further details.
Set the R-net programmable parameter Mode to Switch Control. Refer to the Bluetooth® Programming chapter for further
details.
The procedure to enable Switch Control on the iDevice and assign commands is as follows.
From the iDevice Settings menu, select General > Accessibility.