2.20 PROFILE IDENTIFIER #
NOTE (HP, IN)
If User Menu Position beeps are also set to occur, they will be issued prior to the Profile Identifier beeps.
NOTE (HP, IN)
It is not advisable to program the menu option, ‘Profile Select’, if the Sequence method is being used with Single Switch
Scanner-Type SIDs.
2.21 AXIS IDENTIFIER #
NOTE (HP, IN)
If set to On, there will always be an initial short beep to indicate an axis change. There will then be a short pause before the
series of beeps.
2.22 POSITION #
NOTE (HP, IN)
If a User Menu Position Type is set to List, all items in the list are considered to be one position. See example below.
2.23 USER MENU
NOTE (HP, IN)
When an Omni2 is dispatched from Curtiss-Wright there are no stored IR Codes.
NOTE (HP, IN)
If IR Mode is not available and there are stored IR Codes, then refer to section 8, Configuration.
NOTE (HP, IN)
When an Omni2 is dispatched from Curtiss-Wright, it will contain a default menu as shown in section 9. If required, the IR
Configuration tool can be used to change this default menu.
2.24 LEARNING AN IR CODE
NOTE (HP, IN)
The first time an IR Code has been learnt, it is necessary to cycle the power to the Omni2. If other IR Codes are already learnt,
then this is not necessary.
2.25 DELETING IR CODES
NOTE (HP, IN)
When deleting all learnt Codes for a specific Appliance, the Omni2 must be power-cycled to actually delete the Codes.
NOTE (HP, IN)
If the Delete All Codes Command is selected, the Omni2 must be power-cycled to actually delete the Codes.
To Next Page
Loading...
Need help?
General