EasyManuals Logo

Curtiss-Wright R-NET OMNI2 User Manual

Curtiss-Wright R-NET OMNI2
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #159 background imageLoading...
Page #159 background image
Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 10 Warnings Summary | 159
SK81935-01
2.39 USER ACCESS
NOTE (OP, HP, IN)
Regulatory information can be accessed within the Omni2 via the following sequence:
Enter the Settings Menu.
Select the Bluetooth® option.
Select the Regulatory option.
3 CAUTIONS
3.1 DISPLAY / INPUT SECTION CONNECTOR
CAUTION (HP, IN)
Use only CW supplied cable SA81774.
3.2 GRADIENT TEST
CAUTION (HP, IN)
Before carrying out this test, ensure another person is present to prevent the powerchair from tipping backwards.
4 WARNINGS
4.1 INTRODUCTION
WARNING
Programming and diagnostics should only be conducted by healthcare professionals with in-depth knowledge of PG Drives
Technology electronic control systems. Incorrect programming could result in an unsafe set-up of a vehicle for a user. Curtiss-
Wright accept no liability for any losses of any kind if the programming of the control system is altered from the factory
preset values.
4.2 LCD SCREEN
WARNING (OP, HP, IN)
Do not attempt to operate the powerchair if the LCD screen is damaged or malfunctioning. Curtiss-Wright accept no liability
for losses of any kind arising from failure to comply with this condition.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Curtiss-Wright R-NET OMNI2 and is the answer not in the manual?

Curtiss-Wright R-NET OMNI2 Specifications

General IconGeneral
BrandCurtiss-Wright
ModelR-NET OMNI2
CategoryRecording Equipment
LanguageEnglish