EasyManuals Logo

Curtiss-Wright R-NET OMNI2 User Manual

Curtiss-Wright R-NET OMNI2
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 10 Warnings Summary | 163
SK81935-01
4.19 IR CONFIGURATION TOOL
WARNING (HP, IN)
Programming and diagnostics should only be conducted by healthcare professionals with in-depth knowledge of PG Drives
Technology electronic Control Systems. Incorrect programming could result in an unsafe setup of a vehicle for a user. Curtiss-
Wright accept no liability for any losses of any kind if this condition is not met.
4.20 INTRODUCTION
WARNING (HP, IN)
Diagnostics should only be conducted by healthcare professionals with in-depth knowledge of PG Drives Technology
electronic control systems. An incorrect or badly effected repair could result in an unsafe set-up of a powerchair. Curtiss-
Wright accept no liability for losses of any kind arising from an incorrect or badly effected repair.
4.21 USER SWITCH DETATCHED
WARNING (HP, IN)
Because a disconnected User Switch means there is no emergency-stop function, Curtiss-Wright recommend that Switch
Detect is always set to On. Curtiss-Wright will accept no liability for any losses resulting from any other setting of this
parameter.
4.22 BASIC TESTS
WARNING (HP, IN)
These tests are a minimum recommendation only. It is the responsibility of the service person(s) to perform other tests
relevant to the original trip and powerchair type. Refer to the powerchair’s Technical Manual for exact information of other
tests. Curtiss-Wright accept no liability for losses of any kind arising from the carrying out of the described tests, or from not
carrying out additional relevant tests.
These tests should be conducted in an open space and a restraining device such as a seat belt should always be used. Curtiss-
Wright accept no liability for losses of any kind arising from failure to comply with this condition.
4.23 SERVICING OF DEFECTIVE UNITS
WARNING (OP, HP, IN)
Any replacement work carried out without the powerchair manufacturer’s permission will invalidate the control system’s
warranty.
WARNING (OP, HP, IN)
Curtiss-Wright accept no liability for losses of any kind arising from unauthorized opening, adjustments or modifications to
any component of the R-net control system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Curtiss-Wright R-NET OMNI2 and is the answer not in the manual?

Curtiss-Wright R-NET OMNI2 Specifications

General IconGeneral
BrandCurtiss-Wright
ModelR-NET OMNI2
CategoryRecording Equipment
LanguageEnglish