If set to Swap, then forward and reverse SID commands will select the available actuator axes, and left and right commands
will move the selected axis.
If set to Left/Right, then a left SID command will select the available actuator axes and a right SID command will move the
selected axis. The direction of movement is changed via a short operation of the right SID command within the period defined
by the parameter, Auto Toggle Time.
If set to Right/Left, then a right SID command will select the available actuator axes and a left SID command will move the
selected axis. The direction of movement is changed via a short operation of the left SID command within the period defined
by the parameter, Auto Toggle Time.
2.10 PORTS 1 / 2 – USER MENU
2.10.1 POSITION 1 TO POSITION 16
This sets the position of menu items within the User Menu. The User Menu can have up to 16 lines. If any of the values are
edited, the following additional window will appear.
The programmable options are: Blank, each of the standard R-net Modes and each of the Omni2 Modes – Exit, Speed Adjust,
Sleep, Lights, Settings and Horn.
If set to Blank, then there will be no menu item displayed.
If set to Exit, then selecting that option will take you back to Drive Mode.
To Next Page
Loading...
Need help?
General