This indicates a system trip, i.e. the R-net has detected a problem somewhere in the powerchair’s electrical system. If the
error is in a non-active module, for example in the ISM but Drive Mode is selected, then drive will still be possible, however,
the diagnostic screen will appear intermittently.
Refer to the R-net Technical Manual SK77981 – Diagnostics for a complete description of the Trip Texts and diagnostic
procedures.
12 SETTINGS MENU
The Settings Menu allows access to user-related adjustments. It can be accessed from the User Menu or by pressing the top
right-hand soft-key on the Display Section after the Omni2 has been switched on. A typical Settings Menu display would be as
above.
Each of the menu items are described in the following sections.
SID forward and reverse movements are used to navigate up and down the screen.
12.1 SET TIME
A right SID deflection will enter a sub-menu with the following time-related function options:
Set Time Allows the user to set the current time and date.
Display Time This sets the format of the time display or turns it off. The options are 12hr, 24hr or Off.
To Next Page
Need help?
General