1.4 BLUETOOTH® MODE SCREEN CONFIGURATION
This is a two-stage process. Firstly, a device or devices must be set to On from the Settings Menu. Secondly, for each device a
screen graphic and a name can be set via PC Programming. The following two sections describe each process.
1.4.1 SETTINGS MENU
Enter the Settings Menu, as described in the Operation chapter, and select Bluetooth®.
A screen as below will appear.
Set one or more of the devices to On. The R-net system must now be switched off and on again.
1.4.2 PC PROGRAMMER
There are four branches in the PC Programmer corresponding to the Bluetooth® devices in the Settings Menu.
Within each branch, there are parameters called Device Name and Screen Graphic. These can be programmed to provide a
more familiar name for a device and to set an appropriate screen symbol – a computer, a tablet or a cell phone – for the
device. Refer to the Bluetooth® Programming chapter for further details.
For the remainder of this section, it will be assumed the Device Name parameters have been set per the following screen.
To Next Page
Loading...