EasyManuals Logo

Curtiss-Wright R-NET OMNI2 User Manual

Curtiss-Wright R-NET OMNI2
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #154 background imageLoading...
Page #154 background image
Curtiss-Wright | PG Drives Technology
SK81935-01
154 | R-net Omni2 Technical Manual | Chapter 10 Warnings Summary
2.5 ACCESSING POWERCHAIR FUNCTIONS
NOTE (HP, IN)
It is not advisable to program the menu options, Speed Adjust or Profile Select, if the Sequence method is being used with
scanning operation. Refer to the Programming chapter for further details.
2.6 GENERAL OPERATING PRINCIPLES
NOTE (OP, HP, IN)
This is a typical screen. Depending on SID type, programming or system configuration and status, there may be additional
icons. Refer to the LCD Screen Details section for further information.
2.7 AUTO TOGGLE CHANGE
NOTE (HP, IN)
For further details, refer to the Fwd / Rev Auto Toggle and Auto Toggle Time sections in the Programming chapter.
2.8 ASSOCIATED PROGRAMMING
NOTE (HP, IN)
It is not advisable to program the Switch to Standby parameter in the R-net Power Module when using Single Switch
Scanner-Type SIDs.
2.9 SPEED ADJUST MODE
NOTE (HP, IN)
It is not advisable to program the menu option, ‘Speed Adjust’ if the Sequence method is being used with a Single Switch
Scanner-Type SID. Refer to the Programming chapter for further details.
2.10 INDICATOR ICONS
NOTE (OP, HP, IN)
The Indicator icons will only be visible when a module supporting lighting, e.g. ISM-L, is connected to the system.
2.11 HAZARD ICON
NOTE (OP, HP, IN)
The Hazard and Indicator icons will only be visible when a module supporting lighting, e.g. ISM-L, is connected to the system.
2.12 LIGHTS ICON
NOTE (OP, HP, IN)
The Lights icon will only be visible when a module supporting lighting, e.g. ISM-L, is connected to the system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Curtiss-Wright R-NET OMNI2 and is the answer not in the manual?

Curtiss-Wright R-NET OMNI2 Specifications

General IconGeneral
Input Voltage Range±10 V
Input Impedance1 MΩ
InterfaceEthernet
Operating Temperature-40°C to +85°C
Resolution16 bits
Power Supply9-36V DC