Curtiss-Wright R-NET OMNI2 - 4 Learning an IR Code

Curtiss-Wright | PG Drives Technology
SK81935-01
84 | R-net Omni2 Technical Manual | Chapter 5 – Infrared Control
If a Command is checked, this means it has a stored IR Code. If there is not a check, then there is no stored IR Code for that
Command.
IR Codes can be stored or deleted as detailed in the following sections.
4 LEARNING AN IR CODE
Enter the IR Set-Up Menu and then select an Appliance, e.g. TV. The Commands for the Appliance will appear on the screen as
below.