NOTE (HP, IN)
If User Menu Position beeps are also set to occur, they will be issued prior to the Profile Identifier beeps.
5.6 AXIS IDENTIFIER #
This can be set to issue a number of beeps corresponding to the actuator axis number. The beeps are of a lower tone to the
axis change beep and will occur after that beep.
The beeps will occur regardless of whether Actuator Selection is set to SID or Switch. In the latter case, there will be no beeps
if Exit is the selected “axis”.
5.7 POSITION #
This sets the number of beeps that will occur when a new line (Position) in the User Menu is highlighted. If Sequence
operation is selected, the beeps will also occur, but upon entry to the Mode that corresponds to the User Menu position.
If set to 0, then no beeps will occur for the position.
NOTE (HP, IN)
If a User Menu Position Type is set to List, all items in the list are considered to be one position. See example below.
If the Omni2 is setup as:
Position 1 = Drive
Position 1 Type = List
Position 1 = 1 beep
Position 2 = 2 beeps
Then the User Menu would appear as:
1: Profile 1
2: Profile 2
3: Profile 3
Seating
To Next Page
Loading...