Curtiss-Wright R-NET OMNI2 - 1.2 PC Programming

Curtiss-Wright | PG Drives Technology
SK81935-01
56 | R-net Omni2 Technical Manual | Chapter 3 – Programming
1.2 PC PROGRAMMING
The Omni2 can be programmed using the R-net PC Programmer. Within the PC Programmer parameter tree, there is a branch
called Omni. This branch contains the parameters shown below. The default settings for all these parameters are also shown
below. Refer to the R-net PC Programmer user guide for further details of how to program using this method.
1.2.1 PC PROGRAMMER PARAMETERS