Curtiss-Wright R-NET OMNI2 - 5 Enabling and Disabling IR Codes

Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 5 – Infrared Control | 87
SK81935-01
5 ENABLING AND DISABLING IR CODES
IR Codes can be enabled or disabled in the IR Set-Up Menu. If a Code is disabled it will not transmit and will not appear in the
User Menu.
To disable an IR Code, select the ‘–’ key on the Display Section of the Omni2. Disabled IR Codes appear with an ‘X’ against the
highlighted Command.
To enable an IR Code, select the ‘+’ key on the Display Section of the Omni2. An enabled Code appears with a check against
the highlighted Command.