5.1 PROFILE CHANGE
This can be set to issue no beep, a short beep or a long beep upon a change of Profile.
5.2 MODE CHANGE
This can be set to issue no beep, a short beep or a long beep upon change of Mode.
5.3 USER MENU ENTRY
This can be set to issue no beep, a short beep or a long beep upon entry of the User Menu.
5.4 USER MENU SCROLL
This can be set to issue no beep, a short beep or a long beep when scanning through user menus.
5.5 PROFILE IDENTIFIER #
This can be set to issue a number of beeps corresponding to the Profile number. The beeps are of a lower tone to the Profile
Change, Mode Change and User Menu Entry beeps, and will occur after these.
Depending on how the Omni2 is set-up, the beeps will occur as below.
Menu operation with Drive Position Type set to Entry – no beep sequence supported.
Menu operation with Drive Position Type set to List – beeps will occur when a particular Profile is highlighted on the User
Menu.
Menu operation with Drive Position Type set to Select – beeps will occur when the Profile selection is changed on the User
Menu.
Sequence operation with Drive Position Type set to Entry – no beep sequence supported.
Sequence operation with Drive Position Type set to List – beeps will occur when a particular Profile is entered.
Sequence operation with Drive Position Type set to Select – a Profile Select screen, as shown below, will be entered and the
beeps will reflect the selected Profile. Left and right SID movements will select the next available Profiles and the
corresponding number of beeps will occur. To enter the selected Profile, operate the User Switch.
To Next Page
Loading...
Need help?
General