Curtiss-Wright R-NET OMNI2 User Manual

Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 8 – Diagnostics | 139
SK81935-01
3.35 RIGHT SIGNAL 2 SHORT CIRCUIT
This occurs when the Omni2 has detected that the Right signal from the Port 2 D-type connector has become short-circuit.
Refer to the Specifications chapter for connection details.
 Check the operation of the SID and all cables and connectors between the Omni2 and the Port 2 D-type connector.
If the trip is still present after the above checks have been made, then the SID or Omni2 may be defective. Refer to Section 5.
3.36 LEFT SIGNAL 2 SHORT CIRCUIT
This occurs when the Omni2 has detected that the Left signal from the Port 2 D-type connector has become short-circuit.
Refer to the Specifications chapter for connection details.
 Check the operation of the SID and all cables and connectors between the Omni2 and the Port 2 D-type connector.
If the trip is still present after the above checks have been made, then the SID or Omni2 may be defective. Refer to Section 5.
3.37 FORWARD SIGNAL 2 SHORT CIRCUIT
This occurs when the Omni2 has detected that the Forward signal from the Port 2 D-type connector has become short-circuit.
Refer to the Specifications chapter for connection details.
 Check the operation of the SID and all cables and connectors between the Omni2 and the Port 2 D-type connector.
If the trip is still present after the above checks have been made, then the SID or Omni2 may be defective. Refer to Section 5.
3.38 REVERSE SIGNAL 2 SHORT CIRCUIT
This occurs when the Omni2 has detected that the Reverse signal from the Port 2 D-type connector has become short-circuit.
Refer to the Specifications chapter for connection details.
 Check the operation of the SID and all cables and connectors between the Omni2 and the Port 2 D-type connector.
If the trip is still present after the above checks have been made, then the SID or Omni2 may be defective. Refer to Section 5.
3.39 FIFTH SWITCH 2 SHORT CIRCUIT
This occurs when the Omni2 has detected the Fifth Switch from the Port 2 D-type connector has become short-circuit. Refer
to the Specifications chapter for connection details.
 Check the operation of the SID and all cables and connectors between the Omni2 and the Port 2 D-type connector.
If the trip is still present after the above checks have been made, then the SID or Omni2 may be defective. Refer to Section 5.

Curtiss-Wright R-NET OMNI2 Specifications

General

Brand	Curtiss-Wright
Model	R-NET OMNI2
Category	Recording Equipment
Language	English