If the error is in a non-active module, for example in the ISM but with Drive Mode selected, then drive will still be possible,
however, the diagnostic screen will appear intermittently.
2.1.1 IDENTIFIED MODULE
This identifies which module of the control system has registered the problem.
PM Power Module
JSM Joystick Module
ISM Intelligent Seating/Lighting Module
Omni Display Omni Display Section
Omni Input Omni Input Section
2.1.2 TRIP TEXT
The Trip Text gives a brief description of the trip type.
2.1.3 TRIP CODE
The 4-digit code displayed gives the exact trip that has been recorded.
2.1.4 EXAMPLE
The example screen shown in section 2.1 displays the following information:
Identified Module Omni Input Section Trip
Trip Text SID Detached
Trip Code 0905
This means the Omni2 has detected that the Specialty Input Device (SID) has become disconnected.
2.2 SYSTEM LOG SCREEN
All trips are stored in the system log, whether they have been resolved or are still active. The system log stores the Trip Text
and the number of occurrences. The trips are stored in their respective Modules within the system.
To Next Page
Loading...
Need help?
General