In this window it is possible to adjust all of the Appliances details and add or remove IR Codes.
7.6.2.3 DELETE APPLIANCE
To delete an Appliance and all its functions, highlight the unwanted Appliance and click Delete in the drop-down menu.
7.6.2.4 CLEAR ALL
Clear All deletes all the Appliances and associated Commands within the My Library structure.
8 CONFIGURATION
8.1 CONFIGURATION OF IR CONTROL MODE
Curtiss-Wright factory programming configures Mode 7 to be IR Control Mode. If this programming has been overwritten,
then it may be necessary to re-program as described below. You will know if re-programming is necessary if you cannot
access the IR User Menu when it has learnt Codes. In this instance, programming as below is recommended.
Firstly, determine which Modes are not used. In the sample screen shown below, it is Modes 5 and 6, with Mode 5 the one
that has been chosen for IR Control Mode.
To Next Page
Loading...
Need help?
General