11.4.4.7 SID DISPLACED
If the SID is operated before or just after you switch the control system on, the screen will flash the joystick displaced screen.
You must release and center (where applicable) the SID to resume normal operation. If you do not release the SID within five
seconds the powerchair will not be able to move, even if you release the SID and operate it again. The screen will display a
diagnostic screen at this time. You can reset this condition by switching the Omni2 off and on again.
11.4.4.8 LOCKED
This symbol is displayed if the Omni2 is locked. Refer to the R-net Technical Manual SK77981 – Operation for details of locking
and unlocking.
11.4.4.9 DIAGNOSTIC SCREEN
When the control system safety circuits have operated and the control system has been prevented from moving the
powerchair, a diagnostics screen will be displayed.
To Next Page
Loading...