Below is an example of programming:
Position 1: Seating Position 6: Settings
Position 2: Drive Position 7: Sleep
Position 3: Speed Adjust Position 8: Exit
Position 4: Horn |
Position 5: Lights Position 16: Blank
The User Menu would appear as follows:
NOTE (HP, IN)
It is possible to set items to appear multiple times in the menu.
2.10.2 POSITION 1 TYPE TO POSITION 16 TYPE
This sets the “type” of the menu item on the screen.
There are three programmable options: Entry, List and Select. These parameters affect only menu items that are genuine
R-net Modes, they do not affect the Omni2 Modes.
The best way to explain each of the settings is in a series of examples. (For Single Switch Scanner Type SIDs replace ‘left and
right SID commands’ with ‘short User Switch operations’).
Assume Position 1 = Drive and Position 1 Type = Entry, then the menu item would appear as below.
Drive >
The effect of Entry is to display the Mode Name and an entry >. A right SID command will enter the Mode.
To Next Page
Loading...