11.4.3.2 DISCONNECTING A BLUETOOTH® DEVICE
Enter the Settings Menu and select Bluetooth®. Set the device you wish to disconnect from On to Off.
11.4.3.3 FLIGHT-SAFE MODE
It is common practice to disable wireless transmissions while on an aircraft. Enter the Settings Menu and select Bluetooth®.
Set all the devices to Off.
11.4.4 GENERAL INFORMATION SYMBOLS
11.4.4.1 LIMP
This message is displayed if a User Switch has become disconnected and the Omni2 is programmed to still allow drive, at a
reduced rate.
11.4.4.2 TIMER
This symbol is displayed when the Omni2 is changing between different states. An example would be entering into module re-
configuration.
11.4.4.3 RESTART
When the Omni2 requires a reboot; for example, after a module re-configuration, this symbol will be flashed.
To Next Page
Loading...