NOTE (HP, IN)
When an Omni2 is dispatched from Curtiss-Wright, it will contain a default menu as shown in section 9. If required, the IR
Configuration tool can be used to change this default menu.
The IR Mode Menu is navigated in the usual way:
Forward SID deflections will highlight the Appliance above.
Reverse SID deflections will highlight the Appliance below.
Left or Right SID deflections will enter the highlighted Appliance’s sub-menu, which will contain all the IR Commands for that
Appliance.
Left or Right SID deflections will then activate the highlighted IR Command.
For each Appliance there is a list of associated IR Commands. Using the TV example, Commands such as: On/Off, Channel Up,
Channel Down, Volume Up and Volume Down may be displayed. When the Omni2 is transmitting the selected Command, it is
highlighted with a red background.
To Next Page
Loading...
Need help?
General