User's Manual
167
Procedure
Step 1 Log in to the PC client.
Step 2 Click on the upper-right corner of the page and then click
Access Management
.
You can also click
Access Management
from the configuration list on the home page.
Step 3 Select a remote device from the device tree and then click the
Video
tab.
You can view information on the remote device, such as its model, MAC address, system
version, and more.
Step 4 Select a remote device from the device tree and then click the
Video
tab.
Figure 8-7 Video
Step 5 Set the parameters under the
Main Stream
,
Sub Stream 1
and
Sub Stream 2
tab.
This section uses configuration for the main stream as an example.
1) Click to enable SVC, and then select 1 or 2 from the drop-down list on the right.
SVC refers to the scaled video coding, which can split the video stream to basic stream
and enhanced scale. If you select 1, there is no scaled encoding.
This function is available when the encoding mode is H.264, H.264B or H.264H.
2) Configure the quality parameters of general videos.