User's Manual
196
After the log function is enabled, you can select
Maintain
>
Log
>
Event Logs
on the home page to
search for logs.
8.3.1.4 Email
After you enable the email function, the system sends alarm emails to all added receivers when a
linkage event occurs.
Make sure that the email configuration has been completed. See "8.2.2.3 Email" for detailed
information.
On the alarm configuration page, click
Select
next to
Event Linkage
, select
Send Email
, and then
click
Apply
.
8.3.1.5 Preset
Set preset function. The system links the selected remote device to rotate to the designated preset
point when a linkage event occurs.
Make sure that the PTZ device has been added, and preset has been added. See "5.5.2 Adding
Remote Devices" for detailed information.
Procedure
Step 1 On the alarm configuration page, click
Select
next to
Event Linkage
, and then select
Preset
.
Figure 8-30 Preset
Step 2 Select a PTZ device, and then enter the preset number.
Step 3 (Optional) Click to link multiple PTZ devices to turn to designated presets.
Step 4 Click
Apply
.
8.3.1.6 Picture Storage
Set the picture storage linkage. When a linkage event occurs, a snapshot is taken and saved on the
Device.
When AI by Camera is used, make sure that the remote device has been configured with snapshot
linkage.
On the alarm configuration page, click
Select
next to
Event Linkage
, select
Picture Storage
, and
then click
Apply
.