User's Manual
165
Step 2 Click on the upper-right corner of the page and then click
Access Management
.
You can also click
Access Management
from the configuration list on the home page.
Step 3 Under the
Access Management
tab, select one or remote devices, and then click
Modify
IP
.
●
You can only modify the IP address of initialized devices.
●
You can only modify the IP address of remote devices that are using the private or
ONVIF protocol.
Step 4 Enter the static IP address, subnet mask, gateway, username and password of the remote
device, and then click
Next
.
●
Enter incremental value only when you want to change IP addresses of several devices
at the same time. The system will allocate IP address one by one with the fourth part of
the IP address increasing by the incremental value.
●
If an IP conflict occurs when you change the static IP address, the system will notify you
of the issue. When an IP conflicts happens when you are changing IP addresses in
batches, the system automatically skips the conflicted IP and begins the allocation
according to the incremental value.
●
If you want to change IP addresses of multiple remote devices, make sure that they
share the same username and password.
Figure 8-6 Modify IP (2)
Step 5 Click
OK
.
To Next Page
Loading...
Need help?
General
