EasyManuals Logo

Dahua Technology DHI-IVSS7124 User Manual

Dahua Technology DHI-IVSS7124
688 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #602 background imageLoading...
Page #602 background image
User's Manual
273
Table 8-25 Thermal alarms
Function
Description
Fire alarm
When the thermal camera detects a fire, the alarm signal is transmitted
to the Device, which performs an alarm linkage action.
Temperature alarm
When the thermal camera detects that the temperature is above or
below the threshold value, the alarm signal is transmitted to the Device,
which performs an alarm linkage action.
Temperature
difference alarm
When the thermal camera detects a temperature difference greater than
the set value, the alarm signal is transmitted to the Device, and the
Device will perform an alarm linkage action.
Hot spot alarm
When the maximum temperature detected by the thermal camera is
higher than the set value, the alarm signal is transmitted to the Device,
and the Device will perform an alarm linkage action.
Cold spot alarm
When the lowest temperature detected by the thermal camera is below
the set value, the alarm signal is transmitted to the Device, and the
Device will perform an alarm linkage action.
This section uses the procedure of configuring fire alarm as an example.
Step 1 Click , or click on the configuration page, and then select
EVENT.
Step 2 Select the root node in the device tree on the left.
Step 3 Select Thermal Alarm > Fire Alarm.
Step 4 Click Deployment Time to select schedule from the drop-down list.
After setting deployment period, system triggers corresponding operations when there is
a motion detection alarm in the specified period.
Click
View Schedule to view detailed schedule settings.
If the schedule is not added or the added schedule does not meet actual needs, click
Add Schedule. See "8.8.4 Schedule" for detailed information.
Step 5 Click
Actions to set alarm actions. See "8.4.1 Alarm Actions" for detailed information.
Step 6 Click Save.
8.5 Storage Management
Click or click on the configuration page, select STORAGE. The Local Hard Disk page is
displayed. Manage storage resources (such as recording file) and space, so you can use and improve
utilization ratio of storage space.
The system supports pre-check and routine inspection, and displays health status, so you can obtain
real-time status of device and avoid data loss.
Pre-check: During device operation, the system automatically detects disk status in case of
change (reboot, insert and pull the disk).
Routine inspection: the system carries out routine inspection of the disk continuously. During
device operation, the disk might go wrong due to service life, environment and other factors.
Find out any problems during routine inspection.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dahua Technology DHI-IVSS7124 and is the answer not in the manual?

Dahua Technology DHI-IVSS7124 Specifications

General IconGeneral
BrandDahua Technology
ModelDHI-IVSS7124
CategoryDVR
LanguageEnglish

Related product manuals