EasyManua.ls Logo

Daikin D-BACS - Page 155

Daikin D-BACS
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
138 1.5 Description of Functions
Control Devices
Ventilation Mode and Amount
If these are changed using the remote controller depending on the unit model, they cannot be displayed on the central
remote controller.
To monitor the ventilation mode and amount, check the values on the remote controller.
3P124623-3A
1.5.13 Timer Number Setting
(Only when used with the schedule timer)
Using this together with the schedule timer makes it possible to set on and off times four times a day.
4 times of ON/OFF time can be set up per day. Because, two settings of ON/OFF time are possible to one Schedule
Timer and two Schedule Timers can be registered into a Central Remote Controller.
[Registration]
1. Pressing the "TIMER NO." button causes the number set for timer number 1 to blink.
If no timer setting has been made " " will be displayed.Select the desired timer number by pressing the
"TIMER NO." button.
2. Once the desired timer number is displayed, press the "SET" button.
Press the "SET" button within 10 seconds after the timer number is displayed.
The display will return to how it was after 10 seconds.
The display for timer number 1 will stop blinking and then timer number 2 will start blinking.
3. Select the desired timer number by pressing the "TIMER NO." button.
Once the desired timer number is displayed, press the "SET" button.
The display for timer number 2 will stop blinking.
The " " display will disappear after 3 seconds.
Select " " in the timer number when you do not wish to set a timer number.
It is possible to set only one timer number.
(The times for turning the unit(s) on and off twice a day can be set with a single timer number.)
Timer Number Setting
Group control: select the unit in the individual screen and set the timer number.
Batch control: set the timer numbers for all connected units.
Zone control: set the timer numbers for all zone-registered units.
Call up the zones which you wish to set in the zone screen and set the timer numbers.
L
No.
INDIVIDUALLY
C
12
2
1
1
1
No.
12
2
2
No.
12
1
2
No
.
No
No
.
.
12

Table of Contents

Related product manuals